Confidential
2-53
Error Code F8
Battery harness is detected to be not correctly inserted.
Although this error is usually unlikely to occur, it can be considered to occur due to
noise around the location of setting, power supply voltage fluctuation or problem of
software.
User Check
- Turn the power OFF and ON.
Error Code FE
ROM data acquisition error
User Check
- Turn the power OFF and ON.
Unable to Print F8 LCD
Step Cause Solution
1 Main PCB defective Replace the main PCB ASSY.
Unable to Print FE LCD
Step Cause Solution
1 Program malfunctioning Re-load the firmware.
2 Main PCB defective Replace the main PCB ASSY.
To Next Page
Loading...
