BRP ROTAX 916 i A Series - Type Description

BRP-Rotax
INSTALLATION MANUAL
TYPE DESCRIPTION
The type description consists of the following parts:
e. g. ROTAX
916 iSc 3 A
type
certification
configuration
additional
designation
Designation
Designation Description
Type 916 4-cylinder horizontally opposed, turbocharged engine
Certification iSc Certified to EASA CS-E (TC No.EASA.E.121)
iS Approved to according ASTM F2339
Configuration 2 Propeller shaft with flange for fixed pitch propeller.
3
Propeller shaft with flange for constant speed propeller
and drive for hydraulic governor for constant speed
propeller.
Additional
designation
A High altitude version
C24 24 Volt Board Net Supply version
Options Available options (optional equipment) for the engine type mentioned above:
external
alternator
governor
exhaust system
for configuration 2 YES NO YES
for configuration 3 YES YES YES
NOTE
Conversion of the configuration 2 to configuration 3 and vice versa may be ac-
complished by BRP-Rotax Authorized Distributors or their independent Service
Centers.
Effectivity: 916 i A / C24
Edition 0/Rev. 1
00–00–00
Page 3
December 01 2023