BRP ROTAX 916 i A Series - Control Elements

BRP-Rotax
INSTALLATION MANUAL
Interface
Parameter
Min. Max.
916 i Type A
Nominal
Nominal Input
Voltage
12 V
Internal resistance
Maximum 10 mΩ at
-18 °C (-0.4 °F)
Cold Cranking
Ampere
350 A at -18 °C
(-0.4 °F) (SAE J537)
Capacity
16 Ah
Following battery specifications are recommended:
916 i TYPE C24
Interface
Parameter
Min.
Max.
916 i Type
C24
Nominal
Nominal Input
Voltage
24 V
Internal resistance
Maximum 40 mΩ at
-18 °C (-0.4 °F)
Cold Cranking
Ampere
175 A at -18 °C
(-0.4 °F) (SAE J537)
Capacity
8 Ah
The usage of a battery with lower capacity may have a negative impact on the starting be-
havior of the engine. Additional electrical loads, which are in some cases required by law,
may affect the battery performance during the starting process,(e.g. ACL (Anti Collision
Light), Navigation Light, Avionics).
CONTROL ELEMENTS
916 i TYPE A
START POWER CONTROL
Parameter Value
Contact type Momentary (must not be active after en-
gine start)
Nominal voltage
28 V DC
Nominal current 20 A
24–00–00
Page 22
December 01 2023
Effectivity: 916 i A / C24
Edition 0/Rev. 1