BRP ROTAX 916 i A Series Installation Manual

BRP-Rotax
INSTALLATION MANUAL
WATER INLET ELBOW
NOTICE
The hoses should be fixed with appropriate clips to prevent loss e.g. with spring type
hose clips, such as those used for the coolant hoses between the water pump and
cylinder.
Figure 8.11: Water inlet elbow
1
Water pump housing
2 Water inlet elbow
Use two M6x20 Allen screws lock washers to attach the water inlet elbow. Tighten screws
to 10 Nm (89 in lb.)
NOTICE
The total slip-on length of the water inlet elbow and expansion tank should be used.
EXPANSION TANK
The aircraft manufacturer should give the possibility to the pilots to check the coolant level
in the expansion tank. It is also necessary to inform the pilots about the daily inspection of
the coolant level in the aircraft manufacturers Operators Manual (OM).
To allow this inspection, e.g. a flap or panel on the cowling or a warning instrument in the
cockpit for low coolant level should be installed.
75–00–00
Page 12
December 01 2023
Effectivity: 916 i A / C24
Edition 0/Rev. 1

BRP ROTAX 916 i A Series Specifications

General

Brand	BRP
Model	ROTAX 916 i A Series
Category	Engine
Language	English