BRP ROTAX 916 i A Series - Electrical Interfaces

BRP-Rotax
INSTALLATION MANUAL
ELECTRICAL INTERFACES
Harness interface
connector A
The HIC A connector allows powering ECU Lane A and Fuel Pump A. interfaces to Indica-
tion elements are described in Chapter 77-00-00.
Figure 9.4: HIC A Connector
In case the EMS is powered by an external power source or by one of the internal
generators:
• A connection between Terminal 1 and Terminal 7 will power ECU Lane A
• A connection between Terminal 3 and Terminal 9 will power Fuel pump 1
Figure 9.5: HIC A connector –Engine controls
Effectivity: 916 i A / C24
Edition 0/Rev. 1
76–00–00
Page 7
December 01 2023