2007 Buell P3: Chassis 2-13
HOME
ASSEMBLY
11WARNING1WARNING
Do not allow brake fluid, bearing grease or other lubri-
cants to contact brake rotor or brake pads or reduced
braking ability may occur which could result in death or
serious injury.
1. Lay wheel on clean work area with rotor side down.
2. Position sprocket on rim with holes in sprocket and rim
aligned.
11WARNING1WARNING
Be sure that brake fluid or other lubricants do not con-
tact brake pads or discs. Such contact can adversely
affect braking ability, which could cause loss of control,
resulting in death or serious injury. (00290a)
CAUTION
Do not re-use sprocket mounting screws. Re-using
sprocket mounting screws can result in torque loss and
damage to the sprocket and/or belt assembly. (00480b)
3. Place new hardened washers (Part No. BA0511.2Z) on
sprocket.
4. Position sprocket cover over washers and install to
sprocket with five new sprocket fasteners. Tighten fas-
teners to 28-31 ft-lbs (38-42 Nm).
Do not re-use brake disc screws. Re-using disc screws
can result in torque loss and damage to rotor and/or
brake assembly. (00319b)
5. See Figure 2-9. Install brake rotor (9) to wheel.
a. Verify that the brake rotor is thoroughly clean.
b. Apply Loctite Threadlocker 271 (red) to threads of
each of five new T40 TORX screws (8).
c. Install rotor (9) on wheel hub. Tighten new TORX
screws in criss-cross pattern to 24-27 ft-lbs (33-37
Nm).
Figure 2-9. Rear Wheel Assembly
2
4
7
5
3
9
6
12
1
8
10
1. Nut (metric)
2. Left axle spacer
3. Wheel bearing (left side)
4. Wheel
5. Axle spacer, center
6. Wheel bearing (right side)
7. Rear axle
8. Brake rotor fastener (5)
9. Rear brake rotor
10. Right axle spacer
11. Lockwasher
12. Washer
a0079x2x
11
11
To Next Page
Loading...
