2-34 2007 Buell P3: Chassis
HOME
4. See Figure 2-47. Remove two screws (2) and spacers
(3) to detach master cylinder from footrest support.
5. See Figure 2-48. Detach remote reservoir.
DISASSEMBLY
NOTE
Do not disassemble master cylinder unless problems are
experienced. Discard all seals during the disassembly proce-
dure. Install a complete rebuild kit upon assembly.
1. See Figure 2-49. Slide rubber boot on rod assembly (3)
away from master cylinder body (1).
2. Depress rod assembly (3) and remove internal snap ring
(2). Discard snap ring.
3. Remove piston assembly (4) from master cylinder body.
Figure 2-47. Master Cylinder Mounting
Figure 2-48. Remote Reservoir
7704
2
2
1
1. Banjo bolt (metric)
2. Screw (2) (metric)
3. Spacers
4. Rubber boot
5. Rod adjuster
6. Locknut
7. Clevis
3
3
5
7
4
6
7703
Figure 2-49. Master Cylinder Internals
6506a
1
2
3
4
1. Master cylinder body
2. Snap ring
3. Rod assembly
4. Piston assembly
To Next Page
Loading...
