Buell P3 - Page 158

2007 Buell P3: Chassis 2-53
HOME
11. See Figure 2-87. Wrap the end of the slide pipe and the
slide bushing channel with tape to avoid damaging the oil
seal lip when installing.
12. Coat dust seal, oil seal spacer, and backup ring with fork
oil or sealing grease.
13. See Figure 2-88. Install oil seal spacer and backup ring.
14. See Figure 2-89. Using FORK SEAL DRIVER (Part No.
B-43991), drive the guide bushing with the oil seal
spacer and oil seal into position in the slider assembly.
15. See Figure 2-90. Install retaining ring. Verify ring is
installed securely in the groove inside slider assembly.
Figure 2-87. Slider Tube Protection
Figure 2-88. Oil Seal and Backup Ring
3781
3785
Figure 2-89. Fork Seal Driver
Figure 2-90. Install New Retaining Ring
3787
3786
1. Retaining ring
2. Groove
1
2