Buell P3 - Page 160

2007 Buell P3: Chassis 2-55
HOME
INSTALLATION
1. See Figure 2-95. Install fork assemblies through upper
and lower triple clamps.
NOTE
When installing the front forks, use a screwdriver to pry apart
the triple clamps.
2. See Figure 2-96. Apply Loctite Anti-Seize to the threads
of triple clamp pinch screws.
3. See Figure 2-97. Align and secure fork assemblies.
a. Position fork assemblies so that top of each slider
tube is flush with the top surface of upper triple
clamp. Be sure that top surface of fork is not below
top surface of upper triple clamp.
b. Tighten upper triple clamp pinch screws (at sliders)
to 13-16 ft-lbs (18-22 Nm).
c. Tighten lower triple clamp pinch screws to 22-29 ft-
lbs (30-39 Nm).
d. See Figure 2-98. Tighten headlamp brackets flush
against bottom of top triple clamp.
4. Install front fender. See 2.23 FENDERS.
5. Install front wheel. See 2.5 FRONT WHEEL.
6. Install front brake caliper. See 2.11 FRONT BRAKE
CALIPER.
7. Align headlamp. See 1.22 HEADLAMP.
Figure 2-95. Installing Fork Assemblies
Figure 2-96. Location of Anti-Seize
on Triple Clamp Pinch Screws
3766
3777
Figure 2-97. Upper and Lower Triple Clamp Pinch Screws
Figure 2-98. Tighten Headlamp Bracket Screws
3765
a0065aSx