Adjusting the feed amount
Follow these steps to change the Feed Priority setting.
1. Press the Menu button to display MAIN MENU .
2. Press ◄ or ► to select Med.Detail Set. , and then press the ▼ button.
3. Press ◄ or ► to select the type of paper , and then press the ▼ button.
4. Press ◄ or ► to select Feed Priority , and then press the ▼ button.
5. Press ◄ or ► to select the level of suction against paper on the Band Joint , and then press
the OK button.
The setting is updated, and an equals sign “=” is displayed at left.
Follow the steps below to adjust the feed amount automatically .
1. Prepare one unused sheet A4/Letter-sized or larger when Standard Adj. is selected or two
when Advanced Adj. is selected.
When using a roll, load an unused roll 10 inches (254 mm) or wider .
• Loading Rolls on the Roll Paper Holder (→P .1 15)
• Loading Rolls in the Roll Feed Unit (→P .1 18)
• Loading Sheets in the Cassette (→P .156)
• Loading Sheets Manually (→P .159)
Note
• Always specify the paper type when loading paper . Using paper that you have not specied on the
printer may cause feeding problems and af fect the printing quality .
• W e recommend using the type of paper you use most often for feed amount adjustment.
2. Press the Menu button to display MAIN MENU .
3. Press ◄ or ► to select Adjust Printer , and then press ▼ .
MAIN MENU
Adjust Printer ↓
4. Press ◄ or ► to select Auto Band Adj. , and then press ▼ .
Adjust Printer
Auto Band Adj. ↓
5. Press ◄ or ► to select Standard Adj. , and then press ▼ .
Auto Band Adj.
Standard Adj. ↓
616 Maintenance