Adjusting the feed amount
Adjusting the feed amount during printing
If, during printing, the contrast is uneven sideways across the paper or banding in dif ferent colors appears
every 40 mm (1.6 in) or so, try adjusting the feed amount as follows. However , note that because printing is
paused, colors may be slightly dif ferent.
1. Press the Online button to pause printing.
2. Press the Menu button to display MAIN MENU .
3. Press ◄ or ► to select Fine Band Adj. , and then press the OK button.
MAIN MENU
Fine Band Adj. ↓
4. Press ◄ or ► to change the value, and then press the OK button.
The setting is updated, and an equals sign “=” is displayed at left.
Fine Band Adj.
=+2
Note
• The supported range is -5 to +5.
5. Press the Online button to resume printing.
Note
• The Fine Band Adj. value set during printing is also applied to the next print job. However , if you adjust
the feed amount (manually or automatically), the Fine Band Adj. value is reset to 0.
618 Maintenance
To Next Page
Loading...
Need help?
General