Canon imagePROGRAF iPF5100 - Page 705

Cannot print over a network
Conguring the Communication Mode Manually
This topic gives instructions for conguring the communication mode manually .
1. Press the Menu button to display MAIN MENU .
2. Press ◄ or ► to select Interface Setup , and then press ▼ .
MAIN MENU
Interface Setup ↓
3. Press ◄ or ► to select Ethernet Driver , and then press ▼ .
Interface Setup
Ethernet Driver ↓
4. Press ◄ or ► to select Auto Detect , and then press ▼ .
Ethernet Driver
Auto Detect ↓
5. Press ◄ or ► to select Off , and then press OK .
The setting is updated, and an equals sign “=” is displayed at left.
Auto Detect
= Of f
Return to the Ethernet Driver menu.
6. Press ◄ or ► to select Comm.Mode , and then press ▼ .
Ethernet Driver
Comm.Mode ↓
7. Press ◄ or ► to select the communication mode, and then press the OK button.
The setting is updated, and an equals sign “=” is displayed at left.
Comm.Mode
= Half Duplex
Return to the Ethernet Driver menu.
T roubleshooting 691