5. In IPv6, select On.
6. When there is an IPv6-compatible router in the network environment, select On in Stateless Address.
Additionally, when there is an DHCPv6-compatible server in the network environment, select On in DHCPv6.
Note
• When there is no IPv6-compatible router or DHCPv6-compatible server, select On in Manual and
enter the IPv6 Address and Prefix Length.
7.
Click Set.
8.
Click OK after the Confirmation message is displayed.
9.
Exit imagePROGRAF Device Setup Utility.
Windows Software
>
Device Setup Utility
>
iPF755
Configuring the IP Address Using imagePROGRAF Device Setup Utility
3
413
Downloaded from ManualsPrinter.com Manuals
To Next Page
Loading...
