Security Settings
Item Details Default Setting
New Password Enter the new password.
(0-9999999)
blank
Confirm Enter the new password again to confirm it.
(0-9999999)
blank
*1: On the Security settings screen, besides entering a password, you can specify other security-related information,
such as IP address-based SNMP or TCP usage restrictions, MAC address-based access restrictions, or IPP and
FTP authentication settings.
7.
Click OK to activate the settings.
Configuring the Communication Mode Manually
This topic gives instructions for configuring the communication mode manually.
1. On the Tab Selection screen of the Control Panel, press â—€ or â–¶ to select the Settings/Adj. tab ( ).
Note
• If the Tab Selection screen is not displayed, press the Menu button.
2. Press the OK button.
The Set./Adj. Menu is displayed.
3. Press â–² or â–¼ to select Interface Setup, and then press the OK button.
4. Press â–² or â–¼ to select Ethernet Driver, and then press the OK button.
5. Press â–² or â–¼ to select Auto Detect, and then press the OK button.
6. Press â–² or â–¼ to select Off, and then press the OK button.
The display reverts to the Ethernet Driver menu.
7. Press â–² or â–¼ to select Comm.Mode, and then press the OK button.
Network Setting
>
Other Settings
>
iPF755
Configuring the Communication Mode Manually
10
795
Downloaded from ManualsPrinter.com Manuals
To Next Page
Loading...
