Model 190 Installation, Technical and Operation
8400-M022-O1 Rev J
2. PRECAUTIONS
2.1 Static Electricity
CAUTION! This device contains static sensitive circuit cards
and components. Improper handling of these devices or
printed circuit cards can result in damage to or destruction of
the component or card. Such actual and/or consequential
damage IS NOT covered under warranty and is the
responsibility of the device owner. Electronic components
must be handled only by qualified electronic technicians who
follow the guidelines listed below.
ATTENTION! ALWAYS use a properly grounded wrist strap
when handling, removing or installing electronic circuit cards or
components. Make certain that the wrist strap ground lead is
securely attached to an adequate ground. If you are uncertain
of the quality of the ground, you should consult a licensed
electrician.
ALWAYS handle printed circuit card assemblies by the
outermost edges.
NEVER touch the components, component leads or
connectors.
ALWAYS observe warning labels on static protective bags
and packaging and never remove the card or component from
the packaging until ready for use.
ALWAYS store and transport electronic printed circuit cards
and components in anti-static protective bags or packaging.
2.2 Batteries
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN
INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING
TO THE INSTRUCTIONS.
ATTENTION: RISQUE D'EXPLOSION SI LA BATTERIES EST
REMPLACE'E PAR UN TYPE INCORRECT. REJETEZ LES
BATTERIES UTILISE'ES SELON LES INSTRUCTIONS.
To Next Page
Loading...
Need help?
General
