Cardinal 190 Series - Setup

Model 190 Installation, Technical and Operation
8400-M022-O1 Rev J
Page 171
18.3 Setup
Enter SETUP and proceed to the Options Setup.
option
With option displayed, press the TARE  key. The display will change
to show opt=. Proceed to the opt= parameter.
opt?
With opt? displayed, press the TARE  key. The display will change to
no. Press the Fn/ key to toggle to yes and then press the TARE 
key. The display will change to opt=. Proceed to the opt= parameter.
Otherwise, to skip the Options Setup, press the TARE  key to advance
to the fUnC?. prompt.
oPt= (Option)
Press the TARE  key to show the current setting. If the setting displayed
is acceptable, press the TARE  key again to save it. Otherwise, use the
Fn/▲ key to toggle to a new setting and then press the TARE  key to
save it. Allowable values are:
0 = No Option Card Installed
1 = Serial Interface, Ethernet, WiFi or USB Option Card
Installed
2 = not applicable
3 = not applicable
4 = Digital to Analog Converter Option Card Installed
rAnGE=
Press the TARE  key to show the current setting. If the setting displayed
is acceptable, press the TARE  key again to save it. Otherwise, use the
Fn/▲ key to toggle to a new setting and then press the TARE  key to
save it. Allowable values are:
0 = 4-20 ma
1 = 0-20 ma
2 = 0-24 ma
3 = 0-10 volts
4 = 0-5 volts
5 = -10 to +10 volts
6 = -5 to +5 volts