Model 190 Installation, Technical and Operation
8400-M022-O1 Rev J
3.2 Mounting
Before beginning installation of your Model 190 Indicator, make
certain that it has been received in good condition. Carefully
remove it from the shipping carton and inspect it for any evidence
of damage (such as exterior dents or scratches) that may have
taken place during shipment. Keep the carton and packing material
for return shipment if it should become necessary. It is the
responsibility of the purchaser to file all claims for any damages or
loss incurred during transit.
NOTE: Should your Model 190 indicator come already installed on
a scale, the following information describing the installation of the
indicator does not apply.
The Model 190 indicator is housed in a Thermoplastic IP69K wall or
desk-mount enclosure. The gimbal may be mounted on a desktop
or other smooth, flat, horizontal surface or may be mounted on a
wall. Refer to Figure No. 1 for a layout of wall-mounting bolts.
Figure No. 1
If wall mounted, make certain the mounting surface is strong
enough to support the indicator. The mounting location should be
where the display is easily viewed while being close enough to
provide the operator easy access to the keypad. Carefully lay out
the mounting hole locations, then drill and install the anchor bolts.
Attach the gimbal to the wall and securely tighten the retaining
bolts.
Clearance for
#10 size screw
To Next Page
Loading...