Model 190 Installation, Technical and Operation
8400-M022-O1 Rev J
3.9 Re-Installing the Front Panel
3.9.1. After all terminations have been made, remove the excess
cable from the indicator enclosure and securely tighten
each of the cable gland connectors.
3.9.2. Use a wrench to insure the gland connectors are tight (to
maintain a water-tight seal) but do not over-tighten them.
3.9.3. Make certain no cables or wires are exposed between the
rear housing and front housing assembly and then place
the front housing assembly onto the rear housing.
3.9.4. Secure by tightening the 4 Captive screws loosened
earlier.
To Next Page
Loading...