Model 190 Installation, Technical and Operation
8400-M022-O1 Rev J
4.9 Print Tab Settings
Print
With Print displayed, press the TARE key. The display will change
to port=. Proceed to the port= parameter.
Print?
With Print? displayed, press the TARE key. The display will
change to no. Press the Fn/ key to toggle to yes and then press the
TARE key. The display will change to port=. Proceed to the
port= parameter.
Otherwise, to skip the Print Tab Settings setup, press the TARE key
to advance to the fspan? prompt.
The general format for the input is A =
YY.XX where A is the character identifying
the data printed, YY is the number of lines
down and XX is the number of columns to
the right.
NOTE: Enter 00 in either the YY
or XX location to disable the
data from printing.
Port= (Select Serial Interface for Printing)
Press the TARE key to show the current setting. If the setting
displayed is acceptable, press the TARE key again to save it.
Otherwise, use the Fn/ key to toggle to a new setting and then press
the TARE key to save it. Allowable values are:
0 = Ticket Printing Disabled
1 = Standard Serial Interface used for Printing
2 = Optional Serial Interface used for Printing
(Serial Option Card must be installed)
To Next Page
Loading...