Model 190 Installation, Technical and Operation
8400-M022-O1 Rev J
Once all settings have been entered, click “Save & Reboot” at the bottom
of the webpage in order to save the parameters.
NOTE: It is very important not to press “Enter” before all of
the configuration settings have been properly entered.
Pressing “Enter” prior to entering in all of the appropriate
settings will submit the information and may put the device
into a state where it cannot be connected to. If this
happens, it may be necessary to isolate the 190-WIFI
module from wireless signals and use the DEFAULT jumper
to restore the network to a known configuration.
17.5 WiFi Operation
A connection to the 190-WIFI option card can be used to send commands
to the 190 indicator. A description of the available commands are
describe in section 9.11 ASCII Commands.
To Next Page
Loading...