Cardinal 190 Series - Serial Input;Output

Model 190 Installation, Technical and Operation
8400-M022-O1 Rev J
Page 53
4.8 Serial Input/Output
Sio
With sio displayed, press the TARE  key. The display will change to
baud=. Proceed to the baud= parameter.
Sio?
With sio? displayed, press the TARE  key. The display will change
to no. Press the Fn/ key to toggle to yes and then press the
TARE  key. The display will change to baud=. Proceed to the
baud= parameter. Otherwise, to skip Serial Input/Output setup, press
the TARE  key to advance to the print?. prompt.
bAUd= (Serial Interface Baud Rate)
Press the TARE  key to show the current setting. If the setting displayed
is acceptable, press the TARE  key again to save it. Otherwise, use the
Fn/ key to toggle to a new baud rate for the serial ports and then press
the TARE  key to save it. Allowable settings are:
12 = 1200 Baud
24 = 2400 Baud
48 = 4800 Baud
96 = 9600 Baud
19 = 19200k Baud
38 = 38400 Baud
76 = 76800 Baud
Prty= (Serial Interface Parity Setting)
Press the TARE  key to show the current setting. If the setting
displayed is acceptable, press the TARE  key again to save it.
Otherwise, use the Fn/ key to toggle to a new setting and then press
the TARE  key to save it.
Allowable settings are:
0 = No Parity with 8 data bits
1 = Odd Parity with 7 data bits
2 = Even Parity with 7 data bits