Cardinal 190 Series - Time and Date Functions

Model 190 Installation, Technical and Operation
8400-M022-O1 Rev J
Page 99
8.5 Time and Date Functions
With the Time and Date function enabled during setup of the indicator,
the function must be activated before it can be used.
Refer to section 4.14 Function Setup, the FUnC (FUnC?) parameter to
enable the Fn/ key Time and Date function.
NOTE: With USA=yes, the date format is month-day-year. If USA=no,
the date format is day-month-year.
8.5.1 Set the Time
1. Press and hold the Fn/ key until the display blanks.
2. Once the display blanks, release the Fn/ key
3. Press the TARE  key until the display shows the time prompt,
HH:MM X. Note that X will be A for AM or P for PM.
4. If the time displayed is correct, press the TARE  key to save it.
5. Otherwise, press the Fn/ key to toggle between A and P.
6. Next, press the UNITS/ key to select the digit of the minutes or hour
to change.
7. Press the Fn/ key to change the digit's value.
8. When the correct time is displayed, press the TARE  key to save it.
9. Repeatedly press the TARE  key to step through the remaining
function prompts until the indicator returns to the weight display.
8.5.2 Set the Date
1. Press and hold the Fn/ key until the display blanks.
2. Once the display blanks, release the Fn/ key.
3. Press the TARE  key until the display shows the date prompt.
4. If the date displayed is correct, press the TARE  key to save it.
5. Otherwise, use the UNITS/ key to select the digit of the month, day
or year to change and then use the Fn/ key to change the digit's
value.
6. When the correct date is displayed, press the TARE  key to save it.
7. Repeatedly press the TARE  key to step through the remaining
function prompts until the indicator returns to the weight display.