Cardinal 190 Series - Options Setup

Model 190 Installation, Technical and Operation
8400-M022-O1 Rev J
Page 69
4.13 Options Setup
option
With opt displayed, press the TARE  key. The display will change to
show opt=. Proceed to the opt= parameter.
opt?
With opt? displayed, press the TARE  key. The display will change to
no. Press the Fn/ key to toggle to yes and then press the TARE 
key. The display will change to opt=. Proceed to the opt= parameter.
Otherwise, to skip the Options Setup, press the TARE  key to advance
to the fUnC?. prompt.
opt= (Option)
Press the TARE  key to show the current setting. If the setting displayed
is acceptable, press the TARE  key again to save it. Otherwise, use the
Fn/ key to toggle to a new setting and then press the TARE  key to
save it. Allowable values are:
0 = No Option Card Installed
1 = Serial Interface, Ethernet, WiFi or USB Option Card Installed
(See Appendix C, D, E and G for details)
2 = not applicable
3 = not applicable
4 = Digital to Analog Converter Option Card Installed
(See Appendix F for details)
IMPORTANT! The settings for the following prompts, baUd=,
Prty=, and Cont2= are only applied when the opt= parameter
is set to 0 or 1.
bAUd= (Optional Serial Interface Baud Rate)
Press the TARE  key to show the current setting. If the setting displayed
is acceptable, press the TARE  key again to save it. Otherwise, use the
Fn/ key to toggle to a new baud rate for the serial ports and then press
the TARE  key to save it. Allowable settings are:
12 = 1200 Baud
24 = 2400 Baud
48 = 4800 Baud
96 = 9600 Baud
19 = 19.2k Baud
38 = 38.4k Baud
76 = 76.8k Baud