Model 190 Installation, Technical and Operation
8400-M022-O1 Rev J
5.3 Fn/ Key Combination Features
The Fn/ key is also used in combination with the other keys on the keypad
to access additional indicator features. Those features and their associated
key combinations are as follows:
Fn/, ZERO KEY
This combination will enter the Review mode of Setup and Calibration.
Refer to the Setup Review section of this manual for details.
Fn/, TARE KEY
This combination will display the Tare weight. If a tare weight has not
been stored, then the notArE error message will be displayed.
Fn/, NET/GROSS KEY
This combination will allow viewing of the Audit Trail Counters. Refer to
the View Event Counters section of this manual for details.
Fn/, UNITS/ KEY
This combination will enter the Test Mode/Diagnostics Feature. This
feature is used to conduct a test of all display elements and perform
self-diagnostics. Refer to the Test/Mode/Diagnostics section of this
manual for details.
Fn/, PRINT KEY
This key combination is used for several functions. Print formats are
selected by using the Fn/ key and PRINT keys in combination. Note
that when the PRINT key is pressed the indicator looks for the selected
format. If no visual ticket is found it reverts to the print tab settings.
Refer to section 8.1 for details on Ticket Format Selection.
This key combination is also used to enter the Preset Weight
Comparators “PWC” weight values. Refer to section 8.3 for details on
Preset Weight Comparators.
To Next Page
Loading...