Cardinal 190 Series - Setup

Model 190 Installation, Technical and Operation
8400-M022-O1 Rev J
Page 176
19.3 Setup
Enter SETUP and proceed to the Options Setup.
option
With option displayed, press the TARE  key. The display will
change to show opt=. Proceed to the opt= parameter.
opt?
With opt? displayed, press the TARE  key. The display will
change to no. Press the Fn/ key to toggle to yes and then
press the TARE  key. The display will change to opt=.
Proceed to the opt= parameter. Otherwise, to skip the Options
Setup, press the TARE  key to advance to the fUnC?. prompt.
oPt= (Option)
Press the TARE  key to show the current setting. If the setting
displayed is acceptable, press the TARE  key again to save it.
Otherwise, use the Fn/▲ key to toggle to a new setting and then
press the TARE  key to save it. Allowable values are:
0 = No Option Card Installed
1 = Serial Interface, Ethernet, WiFi or USB Option Card
Installed
2 = not applicable
3 = not applicable
4 = Digital to Analog Converter Option Card Installed
bAUd= (Option Card Baud Rate)
Press the TARE  key to show the current setting. If the setting
displayed is 96, press the TARE  key again to save it. Otherwise,
use the Fn/ key to toggle the baud rate setting to 96 (9600 Baud)
and then press the TARE  key to save it.
NOTE: The default baud rate is 9600 and should not be changed.