Cisco 5510 - ASA SSL / IPsec VPN Edition Configuration Guide

47-20
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 47 Configuring Cisco Intercompany Media Engine Proxy
Configuring Cisco Intercompany Media Engine Proxy
Step 3
hostname(config-uc-ime)# ucm address ip_address
trunk-security-mode [nonsecure | secure]
Example:
hostname(config-uc-ime)# ucm address 192.168.10.30
trunk-security-mode non-secure
Specifies the Cisco UCM server in the enterprise.
You must specify the real IP address of the Cisco
UCM server. Do not specify a mapped IP address for
the server.
Note You must include an entry for each Cisco
UCM in the cluster with Cisco Intercompany
Media Engine that has a SIP trunk enabled.
Where the nonsecure and secure options specify the
security mode of the Cisco UCM or cluster of Cisco
UCMs.
Note Specifying secure for Cisco UCM or Cisco
UCM cluster indicates that Cisco UCM or
Cisco UCM cluster is initiating TLS;
therefore, you must configure TLS for
components. See (Optional) Configuring
TLS within the Local Enterprise,
page 47-28.
You can specify the secure option in this task or you
can update it later while configuring TLS for the
enterprise. See Step 11 in (Optional) Configuring
TLS within the Local Enterprise, page 47-28.
Command Purpose

Cisco 5510 - ASA SSL / IPsec VPN Edition Specifications

General

Brand	Cisco
Model	5510 - ASA SSL / IPsec VPN Edition
Category	Firewall
Language	English