56-17
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 56 Configuring Trend Micro Content Security
Additional References
Additional References
For additional information related to implementing the CSC SSM, see the following documents:
Feature History for the CSC SSM
Table 56-2 lists the release history for this feature. ASDM is backwards-compatible with multiple
platform releases, so the specific ASDM release in which support was added is not listed.
Related Topic Document Title
Instructions on use of the CSC SSM GUI.
Additional licensing requirements of specific
windows available in the CSC SSM GUI.
Reviewing the default content security policies
in the CSC SSM GUI before modifying them or
entering advanced configuration settings.
Cisco Content Security and Control (CSC) SSM Administrator Guide
Accessing ASDM for the first time and
assistance with the Startup Wizard.
Cisco ASA 5500 Series Adaptive Security Appliance Getting Started Guide
Assistance with SSM hardware installation and
connection to the adaptive security appliance.
Cisco ASA 5500 Series Hardware Installation Guide
Technical Documentation, Marketing, and
Support-related information
See the following URL:
http://www.cisco.com/en/US/products/ps6823/index.html.
Table 56-2 Feature History for the CSC SSM
Feature Name Releases Feature Information
CSC SSM ASA 7.0(1) The CSC SSM runs Content Security and Control software, which provides protection
against viruses, spyware, spam, and other unwanted traffic.
The CSC Setup Wizard enables you to configure the CSC SSM in ASDM. The following
screen was introduced: Configuration > Trend Micro Content Security > CSC Setup.
CSC SSM ASA 8.1(1),
ASA 8.1(2)
This feature is not supported.
Syslog format ASA 8.3(1) CSC syslog format is consistent with the adaptive security appliance syslog format.
Syslog message explanations have been added to the Cisco Content Security and Control
(CSC) SSM Administrator Guide. The source and destination IP information has been
added to the ASDM Log Viewer GUI. All syslog messages include predefined syslog
priorities and cannot be configured through the CSC SSM GUI.
To Next Page
Loading...
Need help?
General
