71-25
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 71 Configuring Logging
Feature History for Logging
Feature History for Logging
Table 71-2 lists each feature change and the platform release in which it was implemented. ASDM is
backwards-compatible with multiple platform releases, so the specific ASDM release in which support
was added is not listed.
Table 71-2 Feature History for Logging
Feature Name
Platform
Releases Feature Information
Logging 7.0(1) Provides adaptive security appliance network logging information through
various output destinations, and includes the option to view and save log files.
The Configuration > Device Management > Logging > Logging Setup screen
was introduced.
Rate limit 7.0(4) Limits the rate at which syslog messages are generated.
The Configuration > Device Management > Logging > Rate Limit screen was
modified.
Logging list 7.2(1) Creates a logging list to use in other commands to specify messages by various
criteria (logging level, event class, and message IDs).
The Configuration > Device Management > Logging > Event Lists screen was
modified.
Secure logging 8.0(2) Specifies that the connection to the remote logging host should use SSL/TLS.
This option is valid only if the protocol selected is TCP.
The Configuration > Device Management > Logging > Syslog Server screen was
modified.
Logging class 8.0(4), 8.1(1) Added support for the ipaa event class of logging messages.
The Configuration > Device Management > Logging > Logging Filters screen
was modified.
Logging class and saved
logging buffers
8.2(1) Added support for the dap event class of logging messages.
Added support to clear the saved logging buffers (ASDM, internal, FTP, and
flash).
The Configuration > Device Management > Logging > Logging Setup screen
was modified.
Password encryption 8.3(1) Added support for password encryption.
Log viewers 8.3(1) The source and destination IP addresses were added to the log viewers.
To Next Page
Loading...
Need help?
General
