17-4
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 17 Adding a StandardACL
Feature History for Standard ACLs
Step 6 In the Address field, enter the IP address of the destination to which you want to perform or deny access.
You can also browse for the address of a network object by clicking the ellipsis at the end of the Address
field.
Step 7 (Optional) In the Description field, enter a description that makes an ACE easier to understand.
The description can contain multiple lines; however, each line can be no more than 100 characters in
length.
Step 8 Click OK.
The newly created ACE appears under the ACL.
Step 9 Click Apply to save the ACE to your configuration.
Editing an ACE in a Standard ACL
To edit an ACE in a standard ACL, perform the following steps:
Step 1 Choose Configuration > Firewall > Advanced > Standard ACL.
Step 2 In the main pane, select the existing ACE that you want to edit.
Step 3 Click Edit.
The Edit ACE dialog box appears.
Step 4 Enter the desired changes.
Step 5 Click OK.
Feature History for Standard ACLs
Table 17-2 lists the release history for this feature.
Table 17-2 Feature History for Standard Access Lists
Feature Name Releases Feature Information
Standard ACLs 7.0 Standard ACLs identify the destination IP addresses of
OSPF routes, which can be used in a route map for OSPF
redistribution.
The feature was introduced.
To Next Page
Loading...
Need help?
General
