18-9
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 18 Information About Routing
Information About IPv6 Support
Features that Support IPv6
The following features support IPv6:
Note For features that use the Modular Policy Framework, be sure to use the match any command to match
IPv6 traffic; other match commands do not support IPv6.
• The following application inspections support IPv6 traffic:
–
FTP
–
HTTP
–
ICMP
–
SIP
–
SMTP
–
IPSec-pass-thru
• IPS
• NetFlow Secure Event Logging filtering
• Connection limits, timeouts, and TCP randomization
• TCP Normalization
• TCP state bypass
• Access group, using an IPv6 access list
• Static Routes
• VPN (all types)
Note Failover does not support IPv6. The ipv6 address command does not support setting standby addresses
for failover configurations. The failover interface ip command does not support using IPv6 addresses
on the failover and Stateful Failover interfaces.
IPv6-Enabled Commands
The following adaptive security appliance commands can accept and display IPv6 addresses:
• capture
• configure
• copy
• http
• name
• object-group
• ping
• show conn
• show local-host
To Next Page
Loading...
Need help?
General
