22-5
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 22 Configuring RIP
Customizing RIP
Customizing RIP
This section describes how to configure RIP and includes the following topics:
• Configure the RIP Version, page 22-5
• Configuring Interfaces for RIP, page 22-6
• Configuring the RIP Send and Receive Version on an Interface, page 22-7
• Configuring Route Summarization, page 22-8
• Filtering Networks in RIP, page 22-9
• Redistributing Routes into the RIP Routing Process, page 22-10
• Enabling RIP Authentication, page 22-11
• Restarting the RIP Process, page 22-12
Configure the RIP Version
In ASDM, you can specify the version of RIP used by the adaptive security appliance by performing the
following steps:
Step 1 In the main ASDM window, choose Configuration > Device Setup > Routing > RIP > Setup.
Step 2 Check the Enable RIP routing check box, and click Apply.
Step 3 Check the Enable RIP version check box.
Checking this check box specifies the version of RIP used by the adaptive security appliance. If this
check box is cleared, then the adaptive security appliance sends RIP Version 1 updates and accepts RIP
Version 1 and Version 2 updates. This setting can be overridden on a per-interface basis in the Interface
pane. For more information about configuring interfaces, see the “Configuring Interfaces for RIP”
section on page 22-6.
• Version 1—Specifies that the adaptive security appliance only sends and receives RIP Version 1
updates. Any Version 2 updates received are dropped.
• Version 2—Specifies that the adaptive security appliance only sends and receives RIP Version 2
updates. Any Version 1 updates received are dropped.
Step 4 Click Apply.
To Next Page
Loading...
Need help?
General
