Cisco 5510 - ASA SSL / IPsec VPN Edition Configuration Guide

40-14
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 40 Configuring Inspection for Management Application Protocols
RADIUS Accounting Inspection
Add RADIUS Accounting Policy Map
The Add RADIUS Accounting Policy Map dialog box lets you add the basic settings for the RADIUS
accounting map.
Fields
• Name—Enter the name of the previously configured RADIUS accounting map.
• Description—Enter the description of the RADIUS accounting map, up to 100 characters in length.
• Host Parameters tab:
– Host IP Address—Specify the IP address of the host that is sending the RADIUS messages.
– Key: (optional)—Specify the key.
– Add—Adds the host entry to the Host table.
– Delete—Deletes the host entry from the Host table.
• Other Parameters tab:
– Attribute Number—Specify the attribute number to validate when an Accounting Start is
received.
– Add—Adds the entry to the Attribute table.
– Delete—Deletes the entry from the Attribute table.
– Send response to the originator of the RADIUS message—Sends a message back to the host
from which the RADIUS message was sent.
– Enforce timeout—Enables the timeout for users.
• Users Timeout—Timeout for the users in the database (hh:mm:ss).
Modes
The following table shows the modes in which this feature is available:
RADIUS Inspect Map
The RADIUS pane lets you view previously configured RADIUS application inspection maps. A
RADIUS map lets you change the default configuration values used for RADIUS application inspection.
You can use a RADIUS map to protect against an overbilling attack.
Fields
• Name—Enter the name of the inspect map, up to 40 characters in length.
• Description—Enter the description of the inspect map, up to 200 characters in length.
Firewall Mode Security Context
Routed Transparent Single
Multiple
Context System
••••—

Cisco 5510 - ASA SSL / IPsec VPN Edition Specifications

General

Brand	Cisco
Model	5510 - ASA SSL / IPsec VPN Edition
Category	Firewall
Language	English