40-15
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 40 Configuring Inspection for Management Application Protocols
RADIUS Accounting Inspection
• RADIUS Inspect Maps—Table that lists the defined RADIUS inspect maps. The defined inspect
maps are also listed in the RADIUS area of the Inspect Maps tree.
• Add—Adds the new RADIUS inspect map to the defined list in the RADIUS Inspect Maps table and
to the RADIUS area of the Inspect Maps tree. To configure the new RADIUS map, select the
RADIUS entry in Inspect Maps tree.
• Delete—Deletes the application inspection map selected in the RADIUS Inspect Maps table and
from the RADIUS area of the Inspect Maps tree.
Modes
The following table shows the modes in which this feature is available:
RADIUS Inspect Map Host
The RADIUS Inspect Map Host Parameters pane lets you configure the host parameter settings for the
inspect map.
Fields
• Name—Shows the name of the previously configured RADIUS accounting map.
• Description—Enter the description of the RADIUS accounting map, up to 200 characters in length.
• Host Parameters—Lets you configure host parameters.
–
Host IP Address—Specify the IP address of the host that is sending the RADIUS messages.
–
Key: (optional)—Specify the key.
• Add—Adds the host entry to the Host table.
• Delete—Deletes the host entry from the Host table.
Modes
The following table shows the modes in which this feature is available:
RADIUS Inspect Map Other
The RADIUS Inspect Map Other Parameters pane lets you configure additional parameter settings for
the inspect map.
Firewall Mode Security Context
Routed Transparent Single
Multiple
Context System
••••—
Firewall Mode Security Context
Routed Transparent Single
Multiple
Context System
••••—
To Next Page
Loading...
Need help?
General
