Contents
x
Cisco 4700 Series Application Control Engine Appliance Administration Guide
OL-11157-01
Redundancy Protocol 7-2
Stateful Failover 7-5
FT VLAN 7-6
Configuration Synchronization 7-7
Configuration Requirements and Restrictions 7-8
Redundancy Configuration Quick Start 7-8
Configuring Redundancy 7-12
Configuring an FT VLAN 7-12
Creating an FT VLAN 7-13
Configuring an FT VLAN IP Address 7-13
Configuring the Peer IP Address 7-14
Enabling the FT VLAN 7-15
Configuring an Alias IP Address 7-15
Configuring an FT Peer 7-16
Associating the FT VLAN with the Local Peer 7-16
Configuring the Heartbeat Interval and Count 7-17
Configuring a Query Interface 7-18
Configuring an FT Group 7-19
Associating a Context with an FT Group 7-19
Associating a Peer with an FT Group 7-20
Assigning a Priority to the Active FT Group Member 7-20
Assigning a Priority to the Standby FT Group Member 7-21
Configuring Preemption 7-22
Placing an FT Group in Service 7-23
Modifying an FT Group 7-23
Forcing a Failover 7-24
Synchronizing Redundant Configurations 7-25
Configuring Tracking and Failure Detection 7-28
Overview of Tracking and Failure Detection 7-28
Configuring Tracking and Failure Detection for a Host or Gateway 7-29
To Next Page
Loading...
Need help?
General
