8-19
Cisco 4700 Series Application Control Engine Appliance Administration Guide
OL-11157-01
Chapter 8 Configuring SNMP
SNMP Overview
CISCO-SYSLOG-MIB CISCO-SYSLOG-
CAPABILITY
Describes and stores the system messages
(syslog messages) generated by the ACE. The
CISCO-SYSLOG-MIB provides access to the
syslog messages through SNMP. The MIB
also contains a history of syslog messages and
objects to enable or disable the transmission
of syslog notifications.
Note This MIB does not track messages
that are generated from debug
commands entered through the CLI.
Syslog is described by RFC 3164.
IF-MIB CISCO-IF-CAPABILITY Reports generic informatio
n on interfaces (for
example, VLANs).
The IF-MIB is described in RFC 2863.
Note The Ethernet data port and
port-channel interfaces are available
only in Admin context. In this case,
the IF-MIB supports all the interfaces
for Admin contexts, while each
individual user context supports only
VLAN and BVI interfaces.
IP-MIB CISCO-IP-CAPABILITY Defines managed objects for managing
imp
lementations of the IP and its associated
Internet Control Message Protocol (ICMP),
but excludes their management of IP routes.
The IP-MIB is described in RFC 4293.
SNMPv2-MIB CISCO-SNMPv2-
CAPABILITY
Provides the Management Information Base
fo
r SNMPv2. The management protocol,
SNMPv2, provides for the exchange of
messages that convey management
information between the agents and the
management stations.
The SNMPv2-MIB is described in RFC 3418.
Table 8-1 SNMP MIB Support (continued)
MIB Support Capability MIB Description
To Next Page
Loading...
