Chapter 1 Setting Up the ACE
Synchronizing the ACE with an NTP Server
1-24
Cisco 4700 Series Application Control Engine Appliance Administration Guide
OL-11157-01
Note Only users who are authenticated in the Admin context can use the show ntp
command.
The keywords, arguments, and options are:
• peer-status—Displays the status for all configured NTP servers and peers.
• peers—Displays a listing of all NTP peers.
• statistics—Displays the NTP statistics.
• io—Displays the input/output statistics.
• local—Displays the counters maintained by the local NTP.
• memory—Displays the statistic counters related to the memory code.
• peer—Displays the per-peer statistics counter of a peer.
• ip_address—Displays the peer statistics for the specified IP address.
For example, to display the status for all N
TP servers and peers, enter:
switch/Admin# show ntp peer-status
Table 1-2 describes the fields in the show ntp peer-status command output.
Ta b l e 1-2 Field Descriptions for the show ntp peer-status Command
Field Description
Total Peers Number of associated peers
Remote IP addresses that correspond
to the remote server and
peer entries listed in the configuration file
Local IP addresses that correspond to the local server and peer
en
tries listed in the configuration file
St The stratum
Poll The poll interval (in seconds)
Reach The status of the reachability register (see RFC-1305)
in
octal
Delay The latest delay (in microseconds)
To Next Page
Loading...
