Cisco ASR 9000 Series Routing Configuration Guide

DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Enters static route configuration mode, allowing you to configure
static routing.
router static
Example:
RP/0/RSP0/CPU0:router(config)# router
static
Step 2
Enables BFD fast-detection on the specified IPV4 unicast destination
address prefix and on the forwarding next-hop address.
address-family ipv4 unicast address nexthop
bfd fast-detect [minimum-interval interval]
[multiplier multiplier]
Step 3
•
Include the optional minimum-interval keyword and argument
to ensure that the next-hop is assigned with the same hello
Example:
RP/0/RSP0/CPU0:router(config-static)#
interval. Replace the interval argument with a number that
specifies the interval in milliseconds. Range is from 10 through
10000.
address-family ipv4 unicast 0.0.0.0/0
2.6.0.1 bfd fast-detect minimum-interval
1000 multiplier 5
•
Include the optional multiplier keyword argument to ensure
that the next hop is assigned with the same detect multiplier.
Replace the multiplier argument with a number that specifies
the detect multiplier. Range is from 1 through 10.
Bundle VLAN sessions are restricted to an interval of 250
milliseconds and a multiplier of 3. More aggressive
parameters are not allowed.
Note
Specifies a VPN routing and forwarding (VRF) instance, and enters
static route configuration mode for that VRF.
vrf vrf-name
Example:
RP/0/RSP0/CPU0:router(config-static)# vrf
vrf1
Step 4
Enables BFD fast-detection on the specified IPV4 unicast destination
address prefix and on the forwarding next-hop address.
address-family ipv4 unicast address nexthop
bfd fast-detect
Example:
RP/0/RSP0/CPU0:router(config-static-vrf)#
Step 5
address-family ipv4 unicast 0.0.0.0/0
2.6.0.2
commit
Step 6
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
242
Implementing BFD
BFD for IPv4

Cisco ASR 9000 Series Specifications

General

Brand	Cisco
Model	ASR 9000 Series
Category	Network Router
Language	English