Cisco ASR 9000 Series Routing Configuration Guide

DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Specifies the autonomous system number of the
routing process to configure an EIGRP routing
process.
router eigrp as-number
Example:
RP/0/RSP0/CPU0:router(config)# router eigrp 100
Step 2
Enters a VRF address family configuration mode.address-family { ipv4 | ipv6 }
Example:
RP/0/RSP0/CPU0:router(config-eigrp)# address-family
ipv4
Step 3
Configures the interface on which EIGRP the routing
protocol runs.
interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config-eigrp-af)#
Step 4
interface gigabitEthernet 0/1/5/0
Authenticates all EIGRP protocol traffic on the
interface, based on the MD5 algorithm.
authentication keychain keychain-name
Example:
RP/0/RSP0/CPU0:router(config-eigrp-af-if)#
authentication keychain
Step 5
commit
Step 6
Configuring an Authentication Keychain for an IPv4/IPv6 Interface on a Nondefault VRF
Perform this task to configure an authentication keychain for an IPv4/IPv6 interface on a nondefault VRF.
SUMMARY STEPS
1.
configure
2.
router eigrp as-number
3.
vrf vrf-name
4.
address-family { ipv4 | ipv6 }
5.
interface type interface-path-id
6.
authentication keychain keychain-name
7.
commit
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
330
Implementing EIGRP
Configuring an EIGRP Authentication Keychain

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model