Cisco ASR 9000 Series Routing Configuration Guide

•
Static Routing Commands on Cisco IOS XR Software
•
MPLS Traffic Engineering Commands on Cisco IOS XR Software
Additional References
The following sections provide references related to implementing BFD for Cisco IOS XR software.
Related Documents
Document TitleRelated Topic
Cisco ASR 9000 Series Aggregation Services Router
Routing Command Reference
BFD commands: complete command syntax,
command modes, command history, defaults,
usage guidelines, and examples
Cisco ASR 9000 Series Aggregation Services Router
Modular Quality of Service Configuration Guide
Configuring QoS packet classification
Standards
TitleStandards
—
No new or modified standards are supported by
this feature, and support for existing standards
has not been modified by this feature.
RFCs
TitleRFCs
Bidirectional Forwarding Detection, June 2010
rfc5880_bfd_base
BFD for IPv4 and IPv6 (Single Hop), June 2010
rfc5881_bfd_ipv4_ipv6
BFD for Multihop Paths, June 2010
rfc5883_bfd_multihop
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
298
Implementing BFD
Additional References

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model