Cisco ASR 9000 Series Routing Configuration Guide

Applying Policy When Updating the Routing Table
Perform this task to apply a routing policy to routes being installed into the routing table.
Before You Begin
See the Implementing Routing Policy on Cisco ASR 9000 Series Router module of Cisco ASR 9000 Series
Aggregation Services Router Routing Configuration Guide (this publication) for a list of the supported attributes
and operations that are valid for table policy filtering.
SUMMARY STEPS
1.
configure
2.
router bgp as-number
3.
address-family { ipv4 | ipv6 } unicast
4.
table-policy policy-name
5.
commit
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Specifies the autonomous system number and enters the BGP
configuration mode, allowing you to configure the BGP
routing process.
router bgp as-number
Example:
RP/0/RSP0/CPU0:router(config)# router bgp
120.6
Step 2
Specifies either the IPv4 or IPv6 address family and enters
address family configuration submode.
address-family { ipv4 | ipv6 } unicast
Example:
RP/0/RSP0/CPU0:router(config-bgp)#
address-family ipv4 unicast
Step 3
To see a list of all the possible keywords and arguments for
this command, use the CLI help (?).
Applies the specified policy to routes being installed into the
routing table.
table-policy policy-name
Example:
RP/0/RSP0/CPU0:router(config-bgp-af)#
table-policy tbl-plcy-A
Step 4
commit
Step 5
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
105
Implementing BGP
Applying Policy When Updating the Routing Table

Cisco ASR 9000 Series Specifications

General

Brand	Cisco
Model	ASR 9000 Series
Category	Network Router
Language	English