Cisco ASR 9000 Series

Disabling BGP Flowspec
This procedure disables BGP flowspec policy on an interface.
SUMMARY STEPS
1.
configure
2.
interface type interface-path-id
3.
{ ipv4 } flowspec disable
4.
commit
DETAILED STEPS
Step 1
configure
Step 2
interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config)# interface GigabitEthernet 0/1/1/1
Configures an interface and enters the interface configuration mode.
Step 3
{ ipv4 } flowspec disable
Example:
RP/0/RSP0/CPU0:router(config-if)# ipv4 flowspec disable
Disable flowspec policy on the selected interface.
Step 4
commit
Disable flowspec on the interface
The following example shows you how you can disable BGP flowspec on an interface, and apply another
PBR policy:
Interface GigabitEthernet 0/0/0/0
flowspec [ipv4] disable
int g0/0/0/1
service policy type pbr test_policy
!
!
Disable Flowspec Redirect and Validation
You can disable flowspec validation as a whole for eBGP sessions by means of configuring an explicit knob.
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
223
Implementing BGP Flowspec
Disabling BGP Flowspec