Cisco ASR 9000 Series Routing Configuration Guide

This parameterized policy can then be reused with different parameterization, as shown in the following
example. In this manner, policies that share a common structure but use different values in some of their
individual statements can be modularized. For details on which attributes can be parameterized, see the
individual attribute sections.
route-policy origin-10
if as-path originates-from ‘10.5’ then
apply param-example(10.5)
else
pass
endif
end-policy
route-policy origin-20
if as-path originates-from ‘20.5’ then
apply param-example(20.5)
else
pass
endif
end-policy
The parameterized policy param-example provides a policy definition that is expanded with the values provided
as the parameters in the apply statement. Note that the policy hierarchy is always maintained, Thus, if the
definition of param-example changes, then the behavior of origin_10 and origin_20 changes to match.
The effect of the origin-10 policy is that it adds the community 1234:10 to all routes that pass through this
policy and have an AS path indicating the route originated from autonomous system 10. The origin-20 policy
is similar except that it adds to community 1234:20 for routes originating from autonomous system 20.
Parameterization at Attach Points
In addition to supporting parameterization using the apply statement described in the Parameterization, on
page 556, policies can also be defined that allow for parameterization the attributes at attach points.
Parameterization is supported at all attach points.
In the following example, we define a parameterized policy "param-example". In this example, the policy
takes two parameters "$mymed" and “$prefixset”. Parameters always begin with a dollar sign, and consist
otherwise of any alphanumeric characters. Parameters can be substituted into any attribute that takes a parameter.
In this example we are passing a MED value and prefix set name as parameters.
route-policy param-example ($mymed, $prefixset)
if destination in $prefixset then
set med $mymed
endif
end-policy
This parameterized policy can then be reused with different parameterizations as shown in the example below.
In this manner, policies that share a common structure but use different values in some of their individual
statements can be modularized. For details on which attributes can be parameterized, see the individual
attributes for each protocol.
router bgp 2
neighbor 10.1.1.1
remote-as 3
address-family ipv4 unicast
route-policy param-example(10, prefix_set1)
route-policy param-example(20, prefix_set2)
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
557
Implementing Routing Policy
Parameterization

Cisco ASR 9000 Series Specifications

General

Brand	Cisco
Model	ASR 9000 Series
Category	Network Router
Language	English