Cisco ASR 9000 Series Routing Configuration Guide

Table 10: IS-IS Attributes and Operators
SetMatchAttributeAttach Point
setis, eq, ge, letagredistribution
—
is
The following
route-type
cannot be
matched:
ospf-nssa-type-1
and
ospf-nssa-type-2
Note
route-type
—
indestination
—
innext-hop
—
route-has-labelmpls-label
set
—
level
set
—
isis-metric
set
—
metric-type
—
inrib-has-routedefault-information
originate
set
—
level
set
—
isis-metric
set
—
tag
—
indestinationinter-area-propagate
EIGRP Policy Attach Points
This section describes each of the EIGRP policy attach points and provides a summary of the EIGRP attributes
and operators.
Default-Accept-In
The default-accept-in attach point allows you to set and reset the conditional default flag for EIGRP routes
by evaluating the attached policy.
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
600
Implementing Routing Policy
Attach Points

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model