Cisco ASR 9000 Series Routing Configuration Guide

!
neighbor 2.2.2.2
remote-as 10
update-source Loopback0
address-family ipv4 unicast
!
address-family vpnv4 unicast
!
!
vrf vrf_1
rd 100:1
address-family ipv4 unicast
redistribute connected route-policy pass-all
redistribute ospf 1 match internal external
!
!
!
mpls ldp
router-id 2.2.2.1
interface GigabitEthernet0/2/0/3
!
!
Where to Go Next
To configure route maps through the RPL for OSPF Version 2, see Implementing Routing Policy on Cisco
ASR 9000 Series Router module.
To build an MPLS TE topology, create tunnels, and configure forwarding over the tunnel for OSPF Version
2; see Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide.
Additional References
The following sections provide references related to implementing OSPF.
Related Documents
Document TitleRelated Topic
Cisco ASR 9000 Series Aggregation Services Router
Routing Command Reference
OSPF Commands and OSPFv3 Commands: complete
command syntax, command modes, command history,
defaults, usage guidelines, and examples
Implementing MPLS Traffic Engineering on Cisco
ASR 9000 Series Router module in Cisco ASR 9000
Series Aggregation Services Router MPLS
Configuration Guide
MPLS TE feature information
Cisco ASR 9000 Series Aggregation Services Router
MIB Specification Guide
MIB Reference
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
498
Implementing OSPF
Where to Go Next

Cisco ASR 9000 Series Specifications

General

Brand	Cisco
Model	ASR 9000 Series
Category	Network Router
Language	English