Cisco ASR 9000 Series Routing Configuration Guide

PurposeCommand or Action
Defines the interfaces on which the EIGRP routing
protocol runs.
interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config-eigrp-af)# interface
GigabitEthernet 0/1/0/0
Step 5
Configures a summary aggregate address for the
specified EIGRP interface.
summary-address ip-address { / length | mask } [
admin-distance ]
Example:
RP/0/RSP0/CPU0:router(config-eigrp-af-if)#
summary-address 192.168.0.0/16 95
Step 6
commit
Step 7
Redistributing Routes for EIGRP
This task explains how to redistribute routes, apply limits on the number of routes, and set timers for nonstop
forwarding.
SUMMARY STEPS
1.
configure
2.
router eigrp as-number
3.
address-family { ipv4 }
4.
redistribute {{ bgp | connected | isis | ospf | rip | static } [ as-number ]} [ route-policy name
]
5.
redistribute maximum-prefix maximum [ threshold ] [[ dampened ] [ reset-time minutes ] [ restart
minutes ] [ restart-count number ] | [ warning-only ]]
6.
timers nsf route-hold seconds
7.
maximum paths maximum
8.
maximum-prefix maximum [ threshold ] [[ dampened ] [ reset-time minutes ] [ restart minutes ]
[ restart-count number ] | [ warning-only]]
9.
commit
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
319
Implementing EIGRP
Redistributing Routes for EIGRP

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model