Cisco ASR 9000 Series Routing Configuration Guide

DETAILED STEPS
PurposeCommand or Action
Enters RIB configuration mode.router rib
Example:
RP/0/RSP0/CPU0:router# route rib
Step 1
Disables next-hop dampening for IPv4
address families.
address-family { ipv4 | ipv6 } next-hop dampening disable
Example:
RP/0/RSP0/CPU0:router(config-rib)# address family ipv4
next-hop dampening disable
Step 2
commit
Step 3
Configuring RCC and LCC
Enabling RCC and LCC On-demand Scan
Perform this task to trigger route consistency checker (RCC) and Label Consistency Checker (LCC) on-demand
scan. The on-demand scan can be run on a particular address family (AFI), sub address family (SAFI), table
and prefix, vrf, or all prefixes in the table.
SUMMARY STEPS
1.
Use one of these commands.
•
show rcc {ipv4 | ipv6} unicast [all] [prefix/mask] [vrf vrf-name]
•
show lcc {ipv4 | ipv6} unicast [all] [prefix/mask] [vrf vrf-name]
2.
Use one of these commands.
•
clear rcc {ipv4 | ipv6} unicast [all] [prefix/mask] [vrf vrf-name] log
•
clear lcc {ipv4 | ipv6} unicast [all] [prefix/mask] [vrf vrf-name] log
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
509
Implementing and Monitoring RIB
Configuring RCC and LCC

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model