Cisco IE-5000 User Manual

537
Configuring SNMP
How to Configure SNMP
3. snmp-server group groupname {v1 | v2c | v3
{auth | noauth | priv}} [read readview] [write
writeview] [notify notifyview] [access
access-list]
Configures a new SNMP group on the remote device.
 groupname—Specifies the name of the group.
 Specify a security model:
— v1 is the least secure of the possible security models.
— v2c is the second least secure model. It allows
transmission of informs and integers twice the normal
width.
— v3, the most secure, requires you to select an
authentication level:
auth—Enables the Message Digest 5 (MD5) and the Secure
Hash Algorithm (SHA) packet authentication.
noauth—Enables the noAuthNoPriv security level. This is
the default if no keyword is specified.
priv—Enables Data Encryption Standard (DES) packet
encryption (also called privacy).
Note: The priv keyword is available only when the cryptographic
software image is installed.
 (Optional) read readview—Specifies a string (not to exceed 64
characters) that is the name of the view in which you can only
view the contents of the agent.
 (Optional) write writeview—Specifies a string (not to exceed
64 characters) that is the name of the view in which you enter
data and configure the contents of the agent.
 (Optional) notify notifyview—Specifies a string (not to exceed
64 characters) that is the name of the view in which you
specify a notify, inform, or trap.
 (Optional) access access-list—Specifies a string (not to
exceed 64 characters) that is the name of the access list.
Command Purpose

Cisco IE-5000 Specifications

General

Model	IE-5000
Category	Industrial Ethernet Switch
Switching Capacity	128 Gbps
Forwarding Rate	95.2 Mpps
MAC Address Table Size	16, 000 entries
Ports	16 or 24 10/100/1000 ports
Uplink Ports	4 SFP ports
Operating Temperature	-40°C to 70°C
Power Supply	Dual redundant power supplies
Mounting	DIN rail
Management	Web GUI, CLI, SNMP
Input Voltage	24 VDC or 110/220 VAC
Layer	Layer 2/3
Jumbo Frame Support	Up to 9216 bytes