Cisco IE-5000 User Manual

79
Cisco Systems, Inc. www.cisco.com
Configuring Cisco IOS Configuration
Engine
Prerequisites for Configuring Cisco IOS Configuration
Engine
Set the CNS DeviceID
 When using the Cisco Configuration Engine user interface, you must first set the DeviceID field to the hostname value
that the switch acquires after, not before, you use the cns config initial global configuration command at the switch.
Otherwise, subsequent cns config partial global configuration command operations malfunction.
Enable Automated CNS Configuration
 To enable automated CNS configuration of the switch, you must first complete the prerequisites in Table 1. When
you complete them, power on the switch. At the setup prompt, you do not need to enter a command. The switch
begins the initial configuration as described in the Initial Configuration, page 83. When the full configuration file is
loaded on your switch, you do not need to do anything else.

Cisco IE-5000 Specifications

General

Model	IE-5000
Category	Industrial Ethernet Switch
Switching Capacity	128 Gbps
Forwarding Rate	95.2 Mpps
MAC Address Table Size	16, 000 entries
Ports	16 or 24 10/100/1000 ports
Uplink Ports	4 SFP ports
Operating Temperature	-40°C to 70°C
Power Supply	Dual redundant power supplies
Mounting	DIN rail
Management	Web GUI, CLI, SNMP
Input Voltage	24 VDC or 110/220 VAC
Layer	Layer 2/3
Jumbo Frame Support	Up to 9216 bytes