Cisco IE-5000 User Manual

876
Configuring IP Unicast Routing
Configuring ISO CLNS Routing
 You can configure the LSP refresh interval and the maximum time that an LSP can remain in the router database
without a refresh
 You can set the throttling timers for LSP generation, shortest path first computation, and partial route computation.
 You can configure the switch to generate a log message when an IS-IS adjacency changes state (up or down).
 If a link in the network has a maximum transmission unit (MTU) size of less than 1500 bytes, you can lower the LSP
MTU so that routing will still occur.
 The partition avoidance router configuration command prevents an area from becoming partitioned when full
connectivity is lost among a Level1-2 border router, adjacent Level 1 routers, and end hosts.
BEFORE YOU BEGIN
Enable IS-IS routing as described in the Enabling IS-IS Routing, page 873.

Cisco IE-5000 Specifications

General

Model	IE-5000
Category	Industrial Ethernet Switch
Switching Capacity	128 Gbps
Forwarding Rate	95.2 Mpps
MAC Address Table Size	16, 000 entries
Ports	16 or 24 10/100/1000 ports
Uplink Ports	4 SFP ports
Operating Temperature	-40°C to 70°C
Power Supply	Dual redundant power supplies
Mounting	DIN rail
Management	Web GUI, CLI, SNMP
Input Voltage	24 VDC or 110/220 VAC
Layer	Layer 2/3
Jumbo Frame Support	Up to 9216 bytes