Figure 50: Installing Standoffs and the AEP
Step 4 Insert and tighten three screws to secure the AEP to the backplane.
Step 5 Connect the AEP cable to the backplane and AEP:
a) Connect the 10 colored wires to the wire-wrap pins on the backplane. The following figure shows where
the cable wires are connected. Table 11: Pin Assignments for the AEP, on page 94 shows AEP and AIC-I
signals that each wire carries.
b) Plug the other end of the AEP cable into AEP connector port.
Cisco ONS 15454 Hardware Installation Guide
93
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
NTP-G9 Install the Alarm Expansion Panel (ANSI Only)
To Next Page
Loading...
